CONTROLS AND INDICATORS The LED indicator is capable of flashing any one of three distinct colors: green, yellow, or red, based on logic in the system configuration tool. During the isolator mode, the built-in dual isolators will work at both sides of the module to isolate the line short in front or behind the module.
The modules can be wired for either mode (refer to Figures 3 and 4). The ILED-X modules support two operation modes: polarity insensitive mode and isolator mode. ILED-XC Figure 1 ILED-XC and ILED-XW Remote Lamps ILED-XW MODE OF OPERATION The ILED-X must have a unique address when it works in the device loop. The ILED-X can be installed at any location of a device loop, and it remotely indicates the status of the device(s) in that same loop. The ILED-X can be used when a device already has an accessory. It operates as an additional tri-color LED indicator for a device in the device loop circuit of the Desigo FC2025/FC2050/FV2025/FV2050 and Cerberus PRO FC922/FC924/FV922/FV924 Fire Alarm Systems. 1 INSTALLATION INSTRUCTIONS Models ILED-XC and ILED-XW Intelligent Remote Lamps with Dual Isolators INTRODUCTION The Models ILED-XC (round plate), P/N S54370-B6-A1, and ILED-XW (rectangular plate), P/N S54370-B5-A1, Addressable Remote Lamps from Siemens Industry, Inc., shown in Figure 1.